gnunet/doc/man/gnunet-testbed-profiler.1

.TH GNUNET\-TESTBED\-PROFILER 1 "September 13, 2014" "GNUnet"
.SH NAME
gnunet\-testbed\-profiler \- Profiling driver for the testbed.
.SH SYNOPSIS
.B gnunet\-testbed\-profiler
.RI [ options ]
.br
.SH DESCRIPTION
\fBgnunet\-testbed\-profiler\fP is a command line profiling driver for the testbed.
.SH OPTIONS
.B
.IP "\-c FILENAME,  \-\-config=FILENAME"
Use the configuration file FILENAME.
.B
.IP "\-e COUNT,  \-\-num\-errors=COUNT"
Tolerate COUNT number of continious timeout failures.
.B
.IP "\-H FILENAME,  \-\-hosts=FILENAME"
Name of the file with the login information for the testbed.
.B
.IP "\-h, \-\-help"
Print short help on options.
.B
.IP "\-L LOGLEVEL, \-\-loglevel=LOGLEVEL"
Use LOGLEVEL for logging.  Valid values are DEBUG, INFO, WARNING and ERROR.
.B
.IP "\-l LOGFILE, \-\-logfile=LOGFILE"
Configure logging to write logs to LOGFILE.
.B
.IP "\-n, \-\-non\-interactive"
Run profiler in non-interactive mode where upon testbed setup the
profiler does not wait for a keystroke but continues to run until a
termination signal is received.
.B
.IP "\-p COUNT, \-\-num\-peers=COUNT"
Create COUNT number of peers.
.B
.IP "\-v, \-\-version"
Print GNUnet version number.
.SH BUGS
Report bugs by using Mantis <https://bugs.gnunet.org/> or by sending electronic mail to <gnunet\-developers@gnu.org>
.SH "SEE ALSO"
The full documentation for
.B gnunet
is maintained as a Texinfo manual.  If the
.B info
and
.B gnunet
programs are properly installed at your site, the command
.IP
.B info gnunet
.PP
should give you access to the complete handbook,
.IP
.B info gnunet-c-tutorial
.PP
will give you access to a tutorial for developers.
.PP
Depending on your installation, this information is also
available in
\fBgnunet\fP(7) and \fBgnunet-c-tutorial\fP(7).