Update default IPs

README.md

@@ -55,7 +55,7 @@ after starting `nmrpflash`.
 # nmrpflash -i eth0 -f EX2700-V1.0.1.8.img
 Advertising NMRP server on eth0 ... /
 Received configuration request from a4:2b:8c:00:00:01.
-Sending configuration: ip 10.11.12.252, mask 255.255.255.0.
+Sending configuration: ip 10.164.183.252, mask 255.255.255.0.
 Received upload request: filename 'firmware'.
 Uploading EX2700-V1.0.1.8.img ... OK
 Waiting for remote to respond.
@@ -97,7 +97,7 @@ MAC address. It's also possible that your device does not support the NMRP proto
 ###### "Timeout while waiting for initial reply."
 
 The device did not respond to `nmrpflash`'s TFTP upload request. By default,
-`nmrpflash` will assign `10.11.12.252` to the target device, while adding `10.11.12.253`
+`nmrpflash` will assign `10.164.183.252` to the target device, while adding `10.164.183.253`
 to the network interface specified by the `-i` flag. You can use `-a` to change the IP
 address assigned to the target (e.g. if your network is `192.168.1.0/24`, specify a *free*
 IP address, such as `-a 192.168.1.252`), and `-A` to change the IP address used for the

nmrp.c

@@ -430,10 +430,13 @@ int nmrp_do(struct nmrpd_args *args)
 
 	if (!args->ipaddr) {
 		autoip = true;
-		args->ipaddr = "10.11.12.252";
+		/* The MAC of the device that was used to test this utility starts
+		 * with a4:2b:8c, hence 164 (0xa4) and 183 (0x2b + 0x8c)
+		 */
+		args->ipaddr = "10.164.183.252";
 
 		if (!args->ipaddr_intf) {
-			args->ipaddr_intf = "10.11.12.253";
+			args->ipaddr_intf = "10.164.183.253";
 		}
 	} else if (args->ipaddr_intf) {
 		autoip = true;