#75 Firewall only adds new custom rules after reboot

Closed
opened 5 years ago by burningserenity · 4 comments

I can comment out rules to remove them from the firewall custom rules and restart the firewall. This works just fine. However, when I add a custom rule and restart the firewall, I can see it in the firewall status under the right table, but it doesn't actually do anything until I restart the whole router.

I can comment out rules to remove them from the firewall custom rules and restart the firewall. This works just fine. However, when I add a custom rule and restart the firewall, I can see it in the firewall status under the right table, but it doesn't actually do anything until I restart the whole router.
RISCI_ATOM commented 5 years ago
Collaborator

Did you click "Save & Apply"?

Did you click "Save & Apply"?
burningserenity commented 5 years ago
Poster

I didn't before, but that's because there is no Save & Apply button on that tab, I had to go to the firewall settings all the way to the left, wait for that page to load, then click Save & Apply. Due to your question, I tried just that and I can confirm that I still had to reboot the router in order to apply the rules.

I didn't before, but that's because there is no Save & Apply button on that tab, I had to go to the firewall settings all the way to the left, wait for that page to load, then click Save & Apply. Due to your question, I tried just that and I can confirm that I still had to reboot the router in order to apply the rules.
RISCI_ATOM commented 5 years ago
Collaborator

I am not able to replicate this issue. What release of libreCMC are you using?

I am not able to replicate this issue. What release of libreCMC are you using?
burningserenity commented 5 years ago
Poster

I'm using Think Penguin's latest OEM version.

I'm using Think Penguin's latest OEM version.
Sign in to join this conversation.
Loading...
Cancel
Save
There is no content yet.